flexible shaft BW 6 Z DIN10/DPF without handpiece 24,000-11,000 RPM/1,460-600 watts

Technical information

Dia. drive-side coupling [mm]: 30
Dia. external: 12 mm
Drive-side coupling, DIN: 10
Handpiece-side coupling G: DPF
Handpiece-side coupling dia. [mm]: 10
Height: 12 mm
Length: 1250 mm
Net weight: 0.8 kg
Rotational speed range, from: 9000 RPM
Rotational speed range, to: 18000 RPM
Version: Flexible shaft system 6 DPF/SRF
Width: 12 mm
Packaging unit: 1 piece

Description

Flexible shafts consist of three components which can be combined in different ways: the flexible core (SE), the flexible casing (SCH), the handpiece (HA).

The flexible core consists of four to ten layers of wire, conforming to DIN 2076, and is specially designed for high-speed clockwise rotation. The coupling is securely press-fitted to the core. After approximately 100 operating hours, the core of the flexible shaft must be re-lubricated. The flexible casing consists of oil-resistant rubber; the interior being a flat steel spiral and the outside being solid rubber. The connection couplings are pressed on firmly and encased in a rubber sheath as reinforcement. Because of low noise emissions, continuous operation with little fatigue is possible. Exchangeable collets enable a wide range of tools to be mounted. The sliding coupling enables quick handpiece changes.

Flexible shaft without handpiece with duplex spring coupling DPF.

Recommendations for use

It is essential that the rotational speed and power output do not fall below or exceed the specified ranges.
It is not possible to repair cores and flexible casings. We recommend replacement with pre-assembled new parts.
When using flexible shafts, please ensure that the shafts are not bent beyond the specified radius of curvature. The smallest possible radius of curvature is given for each flexible shaft.
With low power output requirements < 660 watts, it is possible to fall below the rotational speed range.
The radius of curvature should not be smaller than 140 mm.
For maintenance of the flexible shaft, PFERD recommends the P-SET BW 4/6 maintenance set with flexible shaft grease FT 4.

Ordering notes

Special lengths available on request.
Cores and hoses with double-sided sliding coupling on request.

Downloads

Flexible shafts BW 6 Z DIN 10/DPF oH

flexible shaft BW 6 Z DIN10/DPF without handpiece 24,000-11,000 RPM/1,460-600 watts

PFERD Newsletter subscription